Petrol tank install.

So. I bought a tank, which is from Simson moped. Have to do something, so I can mount it into my bike.

Had to fill that hole in front of the tank, so I made plate into it.

Then hammered some curves into the plate

Fits quite fine

Then welded it

Had to put something under the plate, to keep the tank stable. I cut some pipe to half.

There it sits. I like. Have to drill hole into pipe & do threads into frame at the front of the tank.

Last mockup

Back from the countryside. Now have to really focus on this, if I want to drive Him this summer. Here´s The Last Mockup. I found old Simson moped petrol tank and I am going to fit it into this + push handlebars up and there it is. Like this:

Making of a Bat Cave

I am at country side now and we have lots of mosquitos here normally. Not now, because there is so cold. Anyway. I read from net that it is good to make day resting places for Bats, because they eat something like 2000 mosquitos/day. So I did one. Here you can find instructions of how to make one. I did not (of course...) followed those, but followed few quidelines anyway. It must be at least 3 meters from ground & entering hole must not be bigger than 2cm. And it is supposed to be build from raw board, so they can crawl in & hang in there with their claws. It is supposed also to be in some place, where it can get direct sunlight at least 6 hours, so it is warm, when The Bats go to have their daybreak. There can be at least 20 bats in one hotel! Hope they find out mine.


Start

LOL!

Almost ready

Entering hole

Welcome my leather winged friends! Happy hunting.

Trying to make a sissybar part2

Yesterday I did better & taller one. Not ready yet, but soon. After I have finished it,

I´ll post "making of" pictures.

Trying to make a sissybar

Now I am at that point, that I can start to make a sissybar. I have never done this before, but have readed instructions from web. It is quite straightforwarded. You heat metal bar and then bend it! Of course there is lot of things, which I should learn, but I am pretty satisfied about this testing prototype. Have to buy more steel bar (in this case 13mm axle steel) and try to make taller one tomorrow.

Trying to straighten it at start. Should have done first bend at stable metal table.

In any case, it went quite well. This is not just tall enough.

At this pic I have already made those bends, which go over wheel.

Prototype ready.

Seat "problem"

I have tried many seats on this and tried to avoid "normal" solo seat. Yesterday I thought that I´ll have to do one of my own. Today I thought that I´ll give solo seat a try. Have to admit. This is best I have tried on this. Tomorrow I´ll start to do mountings for it.

Rear fender mounting

Started to do mountings for rear fender. These are maybe best mountings I have ever done. Simple and easy to do.

First I put some pipe under the fender to get measurements somewhat right 

Calculating measurements

Busy cat

Then I grinded another end to shape of fender mount pipe.

Did 8mm threads to other end

Fits quite fine

Now tack welding has to be done

And there they are. Have to shorten them little bit, fender is somewhat too close, weld them properly and then they are ready. Now I can start to do sissy bar. 

TCMC Custom Bike Show, Sweden

Did great trip to TCMC Custom Bike Show. Came back yesterday. Trip went well, Sporster worked and weather was good, except few of shower of rains. This was my 14th time to visit there and now Summer officially started for me. Hangover. Over and out.